Gigabyte GA-E350N Manual - Page 24
CPU Host Clock Control
View all Gigabyte GA-E350N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
&& CPU Frequency(MHz) Allows you to manually set the CPU host frequency. Options are 1600MHz. (Default: Normal) && CPU Host Clock Control Enables or disables the control of CPU host clock. Auto (default) allows the BIOS to automatically adjust the CPU host frequency. Manual allows the CPU Frequency (MHz) item below to be configurable. Note: If your system fails to boot after overclocking, please wait for 20 seconds to allow for automated system reboot, or clear the CMOS values to reset the board to default values. (Default: Auto) && CPU Host Clock Allows you to manually set the CPU host clock. The adjustable range is from 100 MHz to 120 MHz. This item is configurable only when CPU Host Clock Control is set to Manual. && Set Memory Clock Determines whether to manually set the memory clock. Manual allows the memory clock control item below to be configurable. Auto lets BIOS automatically set the memory clock as required. Manual allows the memory clock control item below to be configurable. (Default: Auto) && Memory Clock This option is configurable only when Set Memory Clock is set to Manual. Options are: X5.33, X6.66. && DRAM Configuration CMOS Setup Utility-Copyright (C) 1984-2012 Award Software DRAM Configuration DDR3 Timing Items x 1T/2T Command Timing x CAS# latency x RAS to CAS R/W Delay x Row Precharge Time x Minimum RAS Active Time x TwTr Command Delay x Trfc0 for DIMM1 x Trfc1 for DIMM2 x Write Recovery Time x Precharge Time x Row Cycle Time x RAS to RAS Delay x Four Bank Activate Window [Auto] Auto Auto Auto Auto Auto Auto Auto Auto Auto Auto Auto Auto Auto SPD -9T 9T 9T 24T 5T 110ns -10T 5T 33T 4T -- Auto -8T 8T 8T 20T 4T 110ns -8T 4T 27T 4T -- Item Help Menu Level Bank Interleaving [Enabled] Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults && DDR3 Timing Items Manual allows all DRAM timing control items below to be configurable. Options are: Auto (default), Manual. && 1T/2T Command Timing Options are: Auto (default), 1T, 2T. && CAS# latency Options are: Auto (default), 5T~14T. && RAS to CAS R/W Delay Options are: Auto (default), 5T~14T. - 24 -