Gigabyte GA-EP45T-UD3R Manual - Page 26
SATA2_0/1/2/3/4/5 SATA 3Gb/s Connectors, Controlled by ICH10R, Orange, SATA2_0/1/2/3/4/5 SATA 3Gb/s
View all Gigabyte GA-EP45T-UD3R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
9) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10R, Orange) The SATA connectors conform to SA TA 3Gb/s standard and are compatible with SA TA 1.5Gb/s standard. Each SATA connector supports a single SA TA device. The ICH10R controller supports RAID 0, RAID 1, RAID 5 and RAID 10. Refer to Chapter 5, "Configuring SA TA Hard Drive(s)," for instructions on configuring a RAID array. Pin No. Definition 1 GND 2 TXP SATA2_4 SATA2_2 SATA2_0 3 TXN 7 1 4 GND 5 RXN 7 1 6 RXP SATA2_5 SATA2_3 SATA2_1 7 GND Only for GA-EP45T-UD3R. Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number. 9) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10, Orange) The SATA connectors conform to SA TA 3Gb/s standard and are compatible with SA TA 1.5Gb/s standard. Each SATA connector supports a single SA TA device. SATA2_4 7 7 SATA2_5 SATA2_2 SATA2_3 SATA2_0 SATA2_1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND Only for GA-EP45T-UD3. GA-EP45T-UD3R/UD3 Motherboard - 26 -