Gigabyte GA-EX58-UD4 Manual - Page 98
Intel Storage Console, Rebuilding an Array, Enabling Automatic Rebuild
View all Gigabyte GA-EX58-UD4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Rebuilding an Array Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies only to fault-tolerant arrays such as RAID 1, RAID 5, or RAID 10 arrays. The procedures below assume a new drive is added to replace a failed drive to rebuild a RAID 1 array. (Note: The new drive must have equal or greater capacity than the old one.) • Intel ICH10R SATA controller: Turn off your computer and replace the failed hard drive with a new one. Restart your computer. Enabling Automatic Rebuild Step 1: When the message "Press to enter Configuration Utility" appears, press + to enter the RAID Configuration Utility. The following screen appears after you enter the RAID Configuration Utility. Intel(R) Matrix Storage Manager option ROM v8.0.0.1039 ICH10R wRAID5 Copyright(C) 2003-08 Intel Corporation. All Rights Reversed. [ MAIN MENU ] [ DEGRADED VOLUME DETECTED ] "D1eg. rCadreeadtevoRluAmIDe aVnodludmisek available for rebuilding3d. etReecsteedt .DSiesklescttoinNg on-RAID a d2is.kDineliteitaeteRsAa IrDebVuoilldu.mReebuild completes in the op4e. raEtxinitg system. Select the port of the destination disk for rebuilding (ESC to exit): [ DISK/VOLUME INFORMATION ] RAID VolPumoretsD:rive Model None defin1ed. WDC WD800JD-22LS Serial # WD-WMAM9W736333 Size 74.4GB Physical Disks : Port Drive [Mod]-ePl revious/NSeexrtial # [ENTER]-Select 0 WDC WD800JD-22LS WD-WMAM9W736201 1 WDC WD800JD-22LS WD-WMAM9W736333 Size[ESC]-ETxyipt e/Status(Vol ID) 74.4GB Member Disk (0) 74.4GB Non-RAID Disk []-Select [ESC]-Exit [ENTER]-Select Menu Step 2: Select the new hard drive to add into the array to be rebuilt and press . The following screen appears, indicating that an automatic rebuild will be performed automatically after you enter the operating system (look for the Intel Storage Console icon in the notification area, which will show that a RAID volume is being rebuilt). If you do not enable automatic rebuild on this stage, you have to manually rebuild the array in the operating system (see the next page for more details). Intel(R) Matrix Storage Manager option ROM v8.0.0.1039 ICH10R wRAID5 Copyright(C) 2003-08 Intel Corporation. All Rights Reversed. [ MAIN MENU ] 1. Create RAID Volume 2. Delete RAID Volume 3. Reset Disks to Non-RAID 4. Exit RAID Volumes : ID Name 0 gbb [ DISK/VOLUME INFORMATION ] Level RAID1(Mirror) Strip N/A 74.4GB Size Rebuild Status Yes Bootable Physical Disks : Port Drive Model Serial # 0 WDC WD800JD-22LS WD-WMAM9W736201 1 WDC WD800JD-22LS WD-WMAM9W736333 Size 74.4GB 74.4GB Type/Status(Vol ID) Member Disk (0) Member Disk (0) Volumes with "Rebuild" status will be rebuilt within the operating system. []-Select [ESC]-Exit [ENTER]-Select Menu GA-EX58-UD4 Motherboard - 98 -