Gigabyte GA-G41MT-USB3 Manual - Page 35

2-12 Load Optimized Defaults CMOS Setup Utility-Copyright (C) 1984-2011 Award Software  MB Intelligent Tweaker(M.I.T.)  PC Health Status  Standard CMOS Features Load Fail-Safe Defaults  Advanced BIOS Features Load Optimized Defaults  Advanced Chipset Features Set Supervisor Password  Integrated Peripherals  Power Management Setup Set User Password Load Optimized Defa ul ts (Y/NS)?avNe & Exit Setup  PnP/PCI Configurations Exit Without Saving ESC: Quit F8: Q-Flash Select Item F10: Save & Exit Setup Load Optimized Defaults F11: Save CMOS to BIOS F12: Load CMOS from BIOS Press on this item and then press the key to load the optimal BIOS default settings. The BIOS defaults settings help the system to operate in optimum state. Always load the Optimized defaults after updating the BIOS or after clearing the CMOS values. 2-13 Set Supervisor/User Password CMOS Setup Utility-Copyright (C) 1984-2011 Award Software  MB Intelligent Tweaker(M.I.T.)  Standard CMOS Features  Advanced BIOS Features  Advanced Chipset Features  Integrated Peripherals  Power Management SetupEnter Password:  PnP/PCI Configurations  PC Health Status Load Fail-Safe Defaults Load Optimized Defaults Set Supervisor Password Set User Password Save & Exit Setup Exit Without Saving ESC: Quit F8: Q-Flash Select Item F10: Save & Exit Setup Change/Set/Disable Password F11: Save CMOS to BIOS F12: Load CMOS from BIOS Press on this item and type the password with up to 8 characters and then press . You will be requested to confirm the password. Type the password again and press . The BIOS Setup program allows you to specify two separate passwords: Supervisor Password When a system password is set and the Password Check item in Advanced BIOS Features is set to Setup, you must enter the supervisor password for entering BIOS Setup and making BIOS changes. When the Password Check item is set to System, you must enter the supervisor password (or user password) at system startup and when entering BIOS Setup. User Password When the Password Check item is set to System, you must enter the supervisor password (or user password) at system startup to continue system boot. In BIOS Setup, you must enter the supervisor password if you wish to make changes to BIOS settings. The user password only allows you to view the BIOS settings but not to make changes. To clear the password, press on the password item and when requested for the password, press again. The message "PASSWORD DISABLED" will appear, indicating the password has been cancelled. - 35 - BIOS Setup