Gigabyte GA-H81M-S2PV User Manual - Page 14
SATA3 0/1 SATA 6Gb/s Connectors, F_PANEL Front Panel Header, SPEAK, PLED/PWR_LED
View all Gigabyte GA-H81M-S2PV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
B SS 1 S 1 23 1 23 1 1 23 1 1 23 1 5) SATA3 0/1 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. 7 7 Pin No. Definition Pin No. Definition SATA3 1 GND 5 RXN 10 2 TXP 6 RXP 3 TXN 7 GND 1 1 4 GND 6) SATA2 2/3 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. 7 7 Pin No. Definition Pin No. Definition SATA2 1 GND 5 RXN 32 2 TXP 6 RXP 3 TXN 7 GND 1 1 4 GND To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA Configuration," for more information. 7) F_ F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Power Power LED Switch Speaker •• PLED/PWR_LED (Power LED): System Status LED S0 On S3/S4/S5 Off Connects to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED is off when the system is in S3/S4 sleep state PLED+ PLED- PW+ PWSPEAK+ SPEAK- or powered off (S5). 2 20 •• PWF_(Power Switch): SS U 1 19 Connects to the power switch on the chassis front panel. You may 123 HD+ HD- RESRES+ CICI+ PWR_LED+ PWR_LEDPWR_LED- configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more information). Hard Drive Reset Activity LED Switch Power LED Chassis Intrusion Header •• SPEAK (Speaker): Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch): _S Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• CI (Chassis Intrusion Header): Connects to the chassis intrusion switch/sens_oBr on the chassis that can detect if the chaBssSBi_s cover has been removed. This function requires a chassis with a chassis intrusion switch/sensor. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. S B_ B - 14 - _S S_