Gigabyte GA-M56S-S3 Manual - Page 40

English Serial-ATA RAID Config CMOS Setup Utility-Copyright (C) 1984-2007 Award Software Serial-ATA RAID Config x NV SATA Pri-Master RAID x NV SATA Pri-Slave RAID x NV SATA Sec-Master RAID x NV SATA Sec-Slave RAID Enabled Enabled Enabled Enabled Item Help Menu Level` KLJI: Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults NV SATA Pri-Master RAID Enables or disables RAID for the first SATA 3Gb/s connector (SATAII0). This item is configurable only if the Onchip SATA Mode item is set to RAID. (Default: Enabled) NV SATA Pri-Slave RAID Enables or disables RAID for the second SATA 3Gb/s connector (SATAII1). This item is configurable only if the Onchip SATA Mode item is set to RAID. (Default: Enabled) NV SATA Sec-Master RAID Enables or disables RAID for the third SATA 3Gb/s connector (SATAII2). This item is configurable only if the Onchip SATA Mode item is set to RAID. (Default: Enabled) NV SATA Sec-Slave RAID Enables or disables RAID for the fourth SATA 3Gb/s connector (SATAII3). This item is configurable only if the Onchip SATA Mode item is set to RAID. (Default: Enabled) On-Chip IDE Channel0 Enables or disables the first integrated IDE controller. (Default: Enabled) IDE DMA transfer access Enables or disables DMA (Direct Memory Access) mode for the IDE device(s). Disabled turns off DMA mode for the IDE device(s) and lets it operate in PIO (Programmed Input/Output) mode. (Default: Enabled) On-Chip MAC LAN Enables or disables the onboard LAN function. (Default: Auto) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. NV Serial-ATA 1 Enables or disables the integrated SATA controllers. (Default: Enabled) IDE Prefetch Mode Enables or disbales prefetch mode for the integrated IDE controller. Enabled activates the IDE prefetch buffer to enhance hard drive performance. (Default: Enabled) GA-M56S-S3 Motherboard - 40 -