Gigabyte GA-MA770-DS3 Manual - Page 25
SATAII0/1/2/3 SATA 3Gb/s Connectors, PWR_LED System Power LED Header
UPC - 818313004857
View all Gigabyte GA-MA770-DS3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
9) SATAII0/1/2/3 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The AMD SB600 controller supports RAID 0, RAID 1 and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Pin No. Definition 1 GND SATAII1 SATAII0 7 17 1 2 TXP 3 TXN 4 GND 5 RXN 6 RXP 1 71 7 SATAII3 SATAII2 7 GND Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number. 10) PWR_LED (System Power LED Header) This header can be used to connect a system power LED on the chassis to indicate system power status. The LED is on when the system is operating. The LED keeps blinking when the system is in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5). 1 - 25 - Pin No. 1 2 3 Definition MPD+ MPDMPD- System Status LED S0 On S1 Blinking S3/S4/S5 Off Hardware Installation