Gigabyte GA-MA770-DS3 Manual - Page 81
B. Installing Windows Vista
UPC - 818313004857
View all Gigabyte GA-MA770-DS3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
B. Installing Windows Vista (Note) (The procedure below assumes that only one RAID array exists in your system.) Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage), select Load Driver. (Figure 6). Figure 6 Step 2: Specify the location where the driver is saved. Refer to the following two ways: Method A: Insert the motherboard driver disk into your system and browse to the following directory: \Chipset\RS690\Vista\Packages\Drivers\SBDrv\SB6xx\RAID\LH For Windows Vista 64-bit, browse to the LH64A folder. Method B: If you have copied the SATA RAID driver to a floppy disk following the instructions in "5-1-2," insert the floppy disk and browse to the LH (for Windows Vista 32-bit) or LH64A (for Windows Vista 64-bit) folder (Figure 7). Figure 7 (Note) For AHCI drives, installation of Windows Vista does not require you to install the SATA AHCI driver in advance during the OS installation process. - 81 - Appendix