Gigabyte GA-N3150N-D3V User Manual - Page 17

2-2 Advanced Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc. Main Advanced Security Boot Save & Exit OnBoard LAN Controller [Enabled] OnBoard LAN Controller#2 [Enabled] Power Loading [Auto] Max TOLUD [2 GB] Restore AC Power Loss [Power Off] Soft-Off by PWR-BTTN [Instant-off] DDR Voltage Control [Auto] `` Realtek PCIe GBE Family Controller (MAC:40:8D:5C:16:98:54) `` Realtek PCIe GBE Family Controller (MAC:40:8D:5C:16:98:55) `` Hardware Monitor `` SIO Misc Functions `` CPU Configuration `` Intel IGD Configuration `` SATA Configuration `` SIO Configuration `` Network Stack Configuration `` CSM Configuration `` Offboard SATA Controller Configuration `` USB Configuration `` IntelRMT Configuration gf: Select Screen hi: Select Item Enter: Select +/-: Change Opt. F1: General Help F2: Previous Values F3: Optimized Defaults F4: Save & Exit ESC: Exit Version 2.17.1249. Copyright (C) 2015 American Megatrends, Inc. && OnBoard LAN Controller (LAN1) Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. && OnBoard LAN Controller#2 (LAN2) Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. && Power Loading Enables or disables dummy load. When the power supply is at low load, a self-protection will activate causing it to shutdown or fail. If this occurs, please set to Enabled. Auto lets the BIOS automatically configure this setting. (Default: Auto) && Max TOLUD Allows you to configure the maximum TOLUD value. 2 GB is the default. && Restore AC Power Loss Determines the state of the system after the return of power from an AC power loss. Power Off The system stays off upon the return of the AC power. (Default) Power On The system is turned on upon the return of the AC power. Last State The system returns to its last known awake state upon the return of the AC power. && Soft-Off by PWR-BTTN Configures the way to turn off the computer in MS-DOS mode using the power button. Instant-Off Press the power button and then the system will be turned off instantly. (Default) Delay 4 Sec. Press and hold the power button for 4 seconds to turn off the system. If the power button is pressed for less than 4 seconds, the system will enter suspend mode. && DDR Voltage Control Allows you to set the memory voltage. Options are: 1.35V, 1.50V, Auto. Auto lets the BIOS automatically configure this setting. (Default: Auto) - 17 -