Gigabyte GA-P55A-UD6 Manual - Page 95
Configuring JMicron JMB362 SATA Controller
UPC - 818313009067
View all Gigabyte GA-P55A-UD6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
5-1-2 Configuring JMicron JMB362 SATA Controller A. Installing SATA hard drive(s) in your computer Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available SATA port on the motherboard. The JMicron JMB362 SATA controller controls the eSATA ports on the back panel. Then connect the power connector from your power supply to the hard drive. B. Configuring SATA controller mode in BIOS Setup Make sure to configure the SATA controller mode correctly in system BIOS Setup. Step 1: Turn on your computer and press to enter BIOS Setup during the POST (Power-On Self-Test). Make sure eSATA Controller under the Integrated Peripherals menu is enabled (Figure 1). To create RAID, set eSATA Ctrl Mode to RAID. CMOS Setup Utility-Copyright (C) 1984-2009 Award Software Integrated Peripherals Turbo SATA3/USB3.0 Azalia Codec PCI Express x4/x1 Slot Onboard H/W 1394 Onboard H/W LAN1 Onboard H/W LAN2 Green LAN } SMART LAN1 } SMART LAN2 Onboard LAN1 Boot ROM Onboard LAN2 Boot ROM Onboard USB 3.0 Controller Onboard IDE Controller eSATA Controller eSATA Ctrl Mode GSATA Controller GSATA Ctrl Mode GSATA RAID Configuration Onboard Serial Port 1 [Auto] [Auto] [Auto] [Enabled] [Enabled] [Enabled] [Disabled] [Press Enter] [Press Enter] [Disabled] [Disabled [Enabled] [Enabled] [Enabled] [RAID] [Enabled] [IDE] [Press Enter] [3F8/IRQ4] Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults Figure 1 Step 2: Save changes and exit BIOS Setup. The BIOS Setup menus described in this section may differ from the exact settings for your motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you have and the BIOS version. - 95 - Appendix