Gigabyte GA-X48-DQ6 Manual - Page 27
SATAII0/1/2/3/4/5 SATA 3Gb/s Connectors, Controlled by ICH9R, GSATAIIA/GSATAIIB SATA 3Gb/s
UPC - 818313004925
View all Gigabyte GA-X48-DQ6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
9) SATAII0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH9R) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The ICH9R controller supports RAID 0, RAID 1, RAID 5 and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. SATAII0 7 1 1 7 SATAII1 SATAII4 SATAII2 7 17 1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND 1 71 7 SATAII5 SATAII3 10) GSATAIIA/GSATAIIB (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. GSATAIIA 7 1 1 7 GSATAIIB Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number. - 27 - Hardware Installation