Gigabyte GA-Z68X-UD3R-B3 Manual - Page 25
SATA3_0/1 SATA 6Gb/s Connectors, Controlled by Intel Z68 Chipset
View all Gigabyte GA-Z68X-UD3R-B3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
7) SATA3_0/1 (SATA 6Gb/s Connectors, Controlled by Intel Z68 Chipset) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA3_0 and SATA3_1 connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connec- tors with the SATA2_2/3/4/5 connector . (Note) Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM Pin No. Definition SATA3_1 7 1 7 1 SATA3_0 1 GND 2 TXP 3 TXN 4 GND 5 RXN 6 RXP 7 GND 8) SATA2_2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Intel Z68 Chipset) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel Z68 Chipset supports RAID 0, RAID 1, RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configur- ing a RAID array. G.QBOFM G.QBOFPMin No. Definition SATA2_5 7 SATA2_3 1 1 GND 2 TXP 3 TXN 7 SATA2_4 1 SATA2_2 4 GND 5 RXN 6 RXP 7 GND DEBUG PORT (Note) Please connect the L-shaped end of the SATA cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires four hard drives. When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance of the RAID set may vary depending on the devices being connected. - 25 - Hardware Installation