Gigabyte GV-N980X3WA-4GD Manual - Page 2
Factory Default Setup, Introduction of the Control and Display panel - graphics card
View all Gigabyte GV-N980X3WA-4GD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
55 55 55 1 1500 1050 1650 1050 1500 1050 2 3 4 5 Introduction of the Control and Display panel 1 Display Area ● TEMP (°C) : Real-Time display each GPU temperature. ● FAN (rpm) : Displays each fan speed in the WATERCOOLING BOX. ● PUMP (rpm) : Displays each PUMP speed on the graphics card. 2 Mode Switch Button ● Target Temperature: When the button is pressed down, and the lights go on. - Setup the GPU temperature target for three graphics cards in the same time, and then all Fan and Pump speed will be automatically adjusted to your target temperature. *Adjustable Temperature Range : 30~65 °C NOTICE The fan will not spin until the actual temperature reaches to the target setting. ● Fan / Pump control: When the button is released, and the lights go off. - Allows user to manually adjust each Fan and Pump speed. 3 Select the Fan to adjust the speed(rpm). *Available in Fan / Pump control mode. ● Press the button and use the knob to adjust the value. After adjusting, press again to confirm. EX: Press once: Adjust all Fans in the same time; Press twice: Adjust the 1st fan only; Press three times: Adjust the 2nd fan in the same time; Press four times: Adjust the 3rd fan only. *Adjustable RPM Range: 1000~3000 rpm 4 Select the Pump to adjust the speed(rpm). *Available in Fan / Pump control mode. ● Press the button and use the knob to adjust the value. After adjusting, press again to confirm. EX: Press once: Adjust all Pumps in the same time; Press twice: Adjust the 1st Pump; Press three times: Adjust the 2nd Pump in the same time; Press four times: Adjust the 3rd Pump. *Adjustable RPM Range: 1200~1500 rpm 5 Control Knob : Adjusts the Fan speed (rpm) and Pump speed(rpm). NOTICE Before using the WATERFORCE, please make sure the USB cable has well connected to the motherboard, and the graphics card driver, GIGEBYTE OC GURU II has also installed. Factory Default Setup GPU Temperature(°C) Fan Speed(rpm) (±5%) PUMP Speed(rpm) (±5%) Under 40 ≤1000 1500 Remark 65~75 Above 75 ≥2000 Maximum:3000 1500 1500 Please turn off the PC and check if there are any mechanical or Pump related problem. If the GPU temperature remains over 75°C, please contact local service center. 12WE6-IN980WA-00IR