Gigabyte MW70-3S0 Manual - Page 25

12/13) SATA0/SATA1 (SATA 6Gb/s Connectors/SATA4/5 Support SATA DOM Function) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and 1.5Gb/s standard. Each SATA connector supports a single SATA device. Please see page 35 for SATA DOM jumper setting. 7 SATA1 SATA0 1 Normal Mode: Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND SATA DOM Mode: Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP P5V DEBUG PORT 14/15) SATA/2/3/4/5/SSATA0/1/2/3 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and 1.5Gb/s standard. Each SATA connector supports a single SATA device. SSATA3 SSATA2 SSATA1 SSATA0 SATA5 SATA4 SATA3 SATA2 Pin No. Definition 7 1 GND 2 TXP 3 TXN 4 GND 5 RXN 1 6 RXP 7 GND • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. - 25 - Hardware Installation