Haier AD122ALEAA User Manual - Page 14

Installation Manual For Indoor Unit ! Caution Please do not install the unit in places where flammable gases may be leaked. In case that gas is leaked and accumulated around the unit, it may cause dangers of fire etc. The indoor unit shall be installed at locations where cold and hot air could evenly circulated. The following locations should be avoided: Places with rich saline matters (seaside regions). Places with plenty of gas sulfides (mainly in warm spring areas where the copper tube and braze weld is prone to corrosion). Locations with much oil (including mechanical oil) and steam. Locations using organic solvents. Places where there are machines generating HF electromagnetic waves. Positions adjacent to door or window in contact with high-humidity external air. (Easy to generate dew). Locations frequently using special aerosols. Indoor unit 1. Select suitable places the outlet air can be sent to the entire room, and convenient to lay out the connection pipe, connection wire and the drainage pipe to outdoor. 2. The ceiling structure must be strong enough to support the unit weight. 3. The connecting pipe, drain pipe and connection wire Fig 1 shall be able to go though the building wall to connect between the indoor and outdoor units. 4. The connecting pipe between the indoor and outdoor units as well as the drain pipe shall be as short as possible. (See Figure 1) 5. If its necessary to adjust the filling amount of the refrigerant, please refer to the installation manual attached with the outdoor unit. 6. The connecting flange should be provided by the user himself. 7. The indoor unit has two water outlets one of which is obstructed at the factory (with a rubber cap). Only the outlet not obstructed (liquid inlet and outlet side) will be generally used during installation. If applicable, both the outlets should be used together. Important An access port must be provided during installation of indoor unit for maintenance. 13