Haier DW12-PFE1 User Manual - Page 19
Switching the dishwasher OFF
View all Haier DW12-PFE1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
en End of programme Six beeps will indicate that the wash cycle has finished and all the programme indicators light. Switching the dishwasher OFF Several minutes after the programme has ended: Set main switch "A" to OFF. Open the door . Turn the water tap off. (Does not apply when Aquastop unit has been fitted) Remove dishes, etc. when they have cooled down. When the appliance is already underway press the button "A" for 3 seconds, all of the settings will be cancelled. Interrupting the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion. Cancelling or modifying a cycle A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, " Loading the detergent "). To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled "Reset drain function", and select the programme you wish (see the paragraph entitled, "Switching the dishwasher ON") Reset drain function You can use "Reset drain function"to stop the washing cycle under running by pressing and holding the "C1" and "C3" for 3 senconds, and the appliance will stop after a few minutes drain phase. C1 C3 17