Haier DW15-PFESS User Manual - Page 12

End of programme Six beeps will indicate that the wash cycle has finished and the time-remaining indicator " 10 " changes to " : ". 10 Switching the dishwasher OFF Several minutes after the programme has ended: Open the door when the programme has ended: Set ON-OFF Button "A" to OFF. Turn the water tap off. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. Interrupping the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds, and the time remaining indicator " 10 " changes to " " to tell you the door is open. If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion. 10 20 Delayed start programming You can delay the start of a programme in increments of one hour up to 12 hours. Switch dishwasher ON. Immediately press the Delayed Start button " C ", the delayed start indicator "13" blinks and the time-remaining indicator " 10 " changes to " ". Press the Delayed Start button "C" as many times as necessary until the numerical display shows the required delay. To cancel delayed start , press the Delayed Start button "C" until the delayed start indicator "13" goes out. B D C 10 13 E Press programme button " B " to choose the desired programme. Press start button " D ". Close the door, the delayed start timer indicator "13" lights, the time-remaining indicator " 10 " will be indicated by decreasing .The programme will start until the delayed start indicator " 13 " goes out. B D C 10 13 E 21