Haier DW9-CBE0 Instruction Manual - Page 17

en End of programme Six beeps will indicate that the wash cycle has finished and all the programme indicators light. Switching the dishwasher OFF Several minutes after the programme has ended: Open the door. Set ON-OFF button " C " to OFF. Remove dishes, etc. when they have cooled down. Interrupping the programme A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, Loading the detergent). To concel a programme that is underway, press programme button "E" and hold it in for about 3 seconds. Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion. Delayed start programming You can delay the start of a programme in increments of 2 hours up to 12 hours. Switch dishwasher ON. Immediately press the Delayed Start button " I ", the delayed start indicator blinks, the start time for the wash cycle can be delayed for 2,4,6,8,10 or 12 hours. Press the Delayed Start button " I " as many times as necessary until the numerical display shows the required delay. To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator goes out. Press programme button " E " to choose the desired programme. If the the door is closed, the delayed start indicator " H " lights , the delay indicator " H " will blink and decrease, the programme will start until the delayed start indicator " H " goes out . A E B HI C 16