Haier EI39G1MW G1M User Manual - Page 2

5. Install the flow control valve on the water-in pipe. 6. Fix the sprinkler pedestal in a suitable position on the wall. RAIN MASSAGE COMBO Three-gear sprinkler pedestal model) Adjustable wall bracket Expansion screw Sprinkler O-ring rubble gasket Sprinkler hose gasket at the connecting ports on both ends sprinkler hose and the sprinkler in the counterclockwise direction. installation step figure Water saving card is diameter of 6mm and a depth of 35mm in a suitable position on the wall with an electric 3) . Complete the installation (put the sprinkler and the sprinkler hose connector on the adjustable wall bracket). 4). Select the sprinkler mode (adjust the adjustment knob at the lower part of the sprinkler board to the left or the right to select the sprinkler's water-out mode). L R 5 、 ¥ Heating indicator: Electric leakage indicator: When electric leakage is detected, the indicator flashes. button Stepless knob switch: adjust temperature 1.All the indicators are on after the power is turned on, and are off after 2s, then enters the shutdown state. the start-up flow rate,the highest set temperature is reached. ● ● 7 6 Cleaning Not used for a long time If you need to stop using the water heater for a long time, please take the following steps: 1. Cut off the power supply. 2. Close the tap water valve. 3. In order to avoid injuries when the water heater is reused, it is recommended to carefully check whether all components of the water heater are in good condition and whether the pipes leak by water supply before turning on the power supply of the water heater. No water or less water ①Is the water supply cut off or water switch is not ② pipe ① out temperature ② ③ Confirm not æ ç ① code on display screen ç The status indicator only flashes blue. è The status indicator flashes red and blue alternately. turn on the water switch. Carry out inspection and clean or replace the filter screen. power supply to resume. Increase the set temperature. Cut off the power supply and contact the Cut off the power supply and contact the Cut off the power supply and contact the 8