Haier FCD-365HA User Manual - Page 6
Installing Your Freezer
View all Haier FCD-365HA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installing Your Freezer Unpacking Your Freezer 1. Remove all packaging material. This includes the foam base and all adhesive tapes holding the freezer accessories inside and outside. 2. Inspect and remove any remains of packing, tape or printed materials before powering on the freezer. Adjusting Your Freezer • Your freezer is designed for freestanding installation only. It should not be recessed or built-in. • Place the freezer on a floor,which is strong enough to support it fully loaded. • When moving the freezer, never tilt it more than 45-degree angle. This could damage the compressor and the sealed system. • If the freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging. This is to allow the refrigerant to settle. Proper Air Circulation • To assure your freezer works at the maximum efficiency it was designed for you should install it in a location where there is proper air circulation, plumbing and electrical connections. • The following are recommended clearances around the deep freezer: Sides 100mm Top 100mm Back 100mm 5