Haier HBU-14HC03 User Manual - Page 8
Calibration of clock
View all Haier HBU-14HC03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Name of Each Part 12 13 14 15 16 17 11 10 9 MODE AFN SWNIG OTUA 8 TEMP 18 7 CLOCK SET 19 6 20 TES MTIER SLEEP 5 % ROM C 21 N O F FO MA MA MP MP FLTRIEERSET RESET 2 23 24 ON/OFF 4 25 3 26 2 1 1.ON//OFF button 2.Temperature display 11.Humidifying state display 12.Sleep state display 3.Clock display 4.Timer ON/OFF display 5.Humidity display 6.Air filter cleaning display 13.Network control display 14.Working mode display AUTO RUN COOL RUN DRY RUN HEAT RUN FAN RUN When there is too much duct collected on the air inlet, the wire controller will show this display to remind the user to clean the air inlet. After cleaning 15.Electric heating display 16.Operation mode button Used to set working mode: Auto,Cooling,Dry,Heating,Fan and installation, just press the air filter reset button 17.Fan speed button Used to set fan speed: 7.Super/Soft operation display Low Fan, Mid Fan, High Fan, Auto 8.Fan speed display 18.Temperature Setting button AUTO Used to set temperature, temperature range: 16 C~30 C low Mid High Auto 19.Clock button Used to calibrate the time of timer and clock 9.Health state display 20.Setting button 10.Fresh air state display Used to confirm the time of timer and clock 21.Sleep button Used to confirm the time of timer and clock 22.Time Adjusting button Used to adjust the time of timer and clock 23.Reset button When the wire controller appears abnormal condition, use asharppointed article topress this button to make the wirecontroller resume normal 24.Air Filter Reset button After cleaning the air inlet, press thisbutton, the unit can start to operate 25.Timer button Used to set the mode of timer 26.Lock state display Note: 1.Cooling only type air conditioner does not have thedisplay and functions related with heating. 2.This model does not have the following related display and function 5 7 9 10 11 15 . Calibration of clock When turning on the unit for the first time, the clock should be calibrated. The method of calibration is: 1.Press ìClockî button, the Clock display ìAMî ìPMî will flash. 2.Press or to adjust time. For each press, the time will increase or decrease 1 minute. If depressing the button, the time will increase or decrease rapidly. 3.After confirming the time, press ìSetî button, ìAMî or ìPMî will stop flashing, the clock will begin to work. 6