Haier HD90-A2979 UM - New version 1 - Page 24

11-Installation EN 11.1 Preparation ▶ Remove all packaging material. While opening the package, water drops may be seen. This normal phenomenon results from water tests in the factory. ▶ Remove all packaging material including the polystyrene base. Notice Dispose of the packaging in an environmentally friendly manner. For information referring current disposal routes, consult your retailer or the local authorities. WARNING! Following transportation and installation, you MUST leave the dryer to stand for two hours before use. 11.2 Transport and waiting time Transport the appliance in horizontal position only. To the maintenance-free lubrication oil is located in the capsule of the compressor. This oil can get through the closed pipe system during slanting transport. Before connecting the appliance to the power supply you have to wait 2 hours so that the oil runs back into the capsule. 11-1 11.3 Aligning the appliance The appliance should be placed on a flat and solid surface. Set the feet to the desired level (Fig. 11-1). 11-2 11.4 Installation under worktop The dimensions of the recess should at least agree with the dimensions (Fig. 11-2). 1. Put the appliance adjacent to the slot. Make sure that all connections are easily accessible and functional. 2. Adjust accurately all feet to get a firm level position. 3. Install the appliance prudently into the recess. 4. Pay attention to sufficient ventilation. 11-3 11.5 Electrical connection Before each connection check if: ▶ power supply, socket and fusing are appropriate to the rating plate. ▶ the power socket is earthed and no multi-plug or extension. ▶ the power plug and socket are strictly according. ▶ Only UK: The UK plug meets BS1363A standard Put the plug into the socket. (Fig. 11-3). WARNING! If the supply cord is damaged, it must be replaced by the service agent (see warranty card) in order to avoid a hazard! 24