Haier HDW201SS User Manual - Page 9

Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semi-circular filter and cup under running water. To remove the filter assembly, pull on the cup handle in the upward direction. The entire filter assembly (made up of the "A" semicircular filter and the "B" fine filter) should be cleaned at least once a month. To clean the filter and the fine filter, use a cleaning brush. Then, reassemble the filter parts as shown in the figures below and reinsert the entire assembly in the dishwasher, positioning in its seat and pressing downward. The dishwasher must not be used without the filters.Improper replacement of the filters may reduce level of the appliance and damage dishes and utensils. Cleaning the Spray Arms It may happen that food particles become encrusted on the sprayer arms and block the hole (see "Close up view [interior]", letters C-F ). Check the sprayer arms periodically and clean them when needed. A B Troubleshooting It may occur that the dishwasher does not function or does not The Dishes Are Not Clean function properly. Before calling for assistance, check the Have you checked whether: following. - the water is turned on and the hose is connected properly; - the water supply to the house is on and has sufficient pressure; The Dishwasher Does Not Start Have you checked whether: - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. - the plug is pushed into the socket correctly; The Dishwasher Does Not Drain - the power is on in the house; Have you checked whether: - the door is closed properly; - the drain hose is crimped or bent. - the ON-OFF switch is on "ON"; - the water supply is turned on. Lime Deposits or a White Film Form on the Dishes Have you checked whether: - the rinse aid dosage is correct. The Dishwasher Does Not Load Water If, despite all these checks, the dishwasher still does not function and/or the problem persists, contact the nearest authorised ser- Have you checked whether: vice centre and provide them with the following information: - the water is turned on and the hose is connected properly; - the nature of the problem; - the water supply to the house is on and has sufficient pressure; - the model type number (Mod...) and the serial number (S/N...), - the water supply hose is crimped or bent; which are indicated on the plate located on the side of the inner - the filter for the water supply hose is clogged. part of the door. Never call on unauthorised technicians and allow parts which are not original spare parts to be installed . GB .8.