Haier HDY60M User Manual - Page 3

OPERATING INSTRUCTIONS Attention: 1. Before operation, clean off any dust and dirt inside the drum of the dryer with a damp towel; 2. Clean off any debris on the lint filter and in the duct, to increase the drying efficiency. Turning on power Before turning on the power of the dryer, check: - Whether the supply voltage is in accordance with the value indicated on the nameplate; - The dryer must be securely grounded. Preparation of the laundry load - The dryer can only dry laundries which have been spun dry. Do not put in laundry which is still dripping wet or still have excess water. - Make sure all pockets are empty before placing them in the dryer - Pull up zippers, sew and mend up loosened fasteners and tie up dispersed ribbons to prevent the laundry from being entangled. If necessary, put small items in a laundry bag. - To achieve a better drying result, loosen up heavy loads before loading it into the dryer. Load to dry Laundry type Maximum load Cotton fabric 6kg Synthetic fabric 3kg Warning: 1. Avoid drying wool, silk and other delicate fabrics, as it may damage it. 2. Do not exceed the laundry load as suggested. This could damage the dryer as well as the laundry load. Reference weight of fabrics for drying Overalls (cotton appr 950g) Jeans Blended fabric clothes (appr 800g) Pajamas (appr 200g) Shirts (appr 300g) T-shirt (appr 300g) Jackets (cotton appr 800g) Woolen blankets (appr 3000g) Underwear ( appr 70g) Socks (blended fabrics appr 50g) Single bed sheets (cotton appr 800g) 4 OPERATING INSTRUCTIONS 1. Power up Insert the power plug into an appropriate power outlet that is properly installed and grounded. Operating power supply: 220-240V~/50Hz 2. Laundry loading Open the door and load the laundry into the drum of the dryer. For a more energy efficient and better drying result, make sure the load has been spun dry. Try to loosen the load when placing in the dryer. Note: Check labels on clothing before placing them in the dryer. Some articles are not suitable for machine dry. High temperature may damage the fabric. 3. Setting drying time Turn the timer knob to set an optimal drying time according to the laundry.You can choose cool wind cycle or warm cycle according to your needs. Note:Before you set the drying time,ensure your hands are dry. 4. Program completion Warm wind cycle: Before the drying time comes to end, the dryer will interject cold air to cool off the clothes. After the timer stops,the arrowhead of the timer knob will point to OFF. Open the door to remove the laund. ry Cool wind cycle: Throughout the cycle,the heater does not activate.The laundary is dried by cool wind. Note:1.To avoid timer interruption,please do not turn the timer knob to the gray area of the program cycle. 2.Clothes should go through a cooling down/airing phase of the cycle. If for any reason the dryer is stopped before the cycle has finished,dry clothes should be removed immediately and not left in the dryer.Clothes should be spread out to cool and not left bunched eg.in a clothes basket. Before you open the door, please switch off the power supply. 5. Cleaning the dryer Please clean the filter after use every time. 5