Haier HGRA202EAWW User Manual - Page 17
Top Burner Height
View all Haier HGRA202EAWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
ALIGNMENTS AND ADJUSTMENT, Continued In the event of a power failure, the top burners can be lit by holding a lighted match near the burner head and turning the appropriate top burner knob to the "LITE" position. Top Burner Height Make sure the top burners are properly positioned. The top of the burner head should be level with the surface of the main top. To check, lay a straight edge such as a 12-inch ruler across the burner bowl opening. The ruler should rest squarely on the top while in contact with the burner head. If the burner is too high (make sure the burner is cool), push it down. Supply enough force with the palm of you hand to accomplish this adjustment. To raise, pull up on the burner support at the center of the support. 5. Oven Control (Thermostat) The oven control has a flame safety device built into the body of the thermostat. Presence of a gas ignition source (pilot) is verified by a flame safety probe. This flame safety probe actuates the internal safety device to allow gas into the oven burner when the oven is turned on. If there is a loss of gas ignition during operation, the flame safety device will close off gas flow to the oven burner and pilot. The oven burner orifice is located on a brass injector stud at the rear of the oven under the oven floor. This orifice is dedicated to the gas for which the oven is to be used. The orifice is not adjustable. It must be changed completely to convert from one gas to the other. DO NOT DISCARD THE UNUSED ORIFICE. It should be saved in order to convert the range back to its original fuel. Mounting Nut Orifice Oven Burner Injector Stud When converting the oven thermostat to LP (Propane) gas, the minimum bypass screw must be screwed in all the way until it tightens. To convert back to natural gas, turn the screw counterclockwise until the minimum burner flames appear as a row of 1/8" diameter dots along the side of the burner. Minimum Bypass Screw Front Face of Thermostat with Oven Knob Removed 17 End of Control Stem