Haier HGRA202EAWW User Manual - Page 19
Oven Safety Valve, Oven Burner
View all Haier HGRA202EAWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
ALIGNMENTS AND ADJUSTMENT, Continued Hot Oven Restart If you turn off the oven but then decide to turn it back on before it has cooled to room temperature, the burner may not light properly. This is due to the thermostat still sensing a heated oven and not allowing the maximum gas flow rate into the burner. Press in and turn the oven control knob counter clockwise all the way to the "BROIL" position to relight the burner. After the burner has ignited, you may adjust the oven control to the desired temperature. If the oven burner does not ignite and maintain the flame, one of the following situations may have occurred. 1. The pilot burner has gone out. Relight the oven pilot. 2. The pilot will not keep the flame safety probe heated. Adjust the size of the pilot flame. Or, the thermocouple connection at the thermostat may need to be tightened. 3. The flame safety probe may not be properly located. Locate the probe directly over the pilot burner. On spark ignition ovens, the end of the flame safety probe must very close to the side of the burner right in front of the flame ports. 4. The burner is not in its proper position. Make sure the rear of the burner is seated on the injector elbow and the front is bolted onto the burner support. 5. The spark ignitor is defective. Contact an authorized service technician. 6. The glow bar ignitor is defective. Contact an authorized service technician. 6. Oven Burner Air Shutter Adjustment The oven burner flame should be a clean, blue flame with distinct inner cones approximately _" long. A soft, lazy flame with indistinct cones means too much gas or not enough air. A noisy lifting flame means too much air. If adjustments are necessary you must first loosen the lock screw located at the top of the air shutter, then rotate the air shutter to correct setting, and retighten screw. OVEN BURNER LOCK SCREW AIR SHUTTER ORIFICE 1/2'' CONE OVEN SAFETY VALVE OVEN BURNER Oven burner flame can be checked as follows (without burner baffle in place): • To correct a yellow flame-Increase size of air shutter opening. • To correct a lifting, but distinct, blue flame-Decrease size of air shutter opening. The air shutter should be set approximately 2/3 open for natural gas, and approximately full open on LP (Propane) gas. 19