Haier HL22XSLW2 Product Manual - Page 7
Remote control, Battery loading, Precautions
View all Haier HL22XSLW2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Introduction Remote Control Battery loading 1. Slide open the cover of the battery compartment on the back of the remote controller. 2. Load two (AAA) alkaline batteries in the compartment, (plus and minus poles to respective mark) 3. Replace the cover of the battery compartment. Precautions 1. As strong light may interfere the signals, change your position to operate the remote controller if the television cannot be turned on or off as you expect. 2. Keep the remote controller away from heat source or humid area to ensure effective performance of the Remote control remote controller. 3. Make sure that two AAA alkaline batteries are loaded. The batteries must be of the same type. The batteries must be located properly. The batteries are not rechargeable. 4. Make sure that there is no obstacle between the remote controller and television set. The remote control cannot be operated unless the batteries are properly loaded. When using the remote control, aim it at the remote sensor on the TV. PICTURE 1 AUDIO 14 15 ARC CCD MTS/SAP SLEEP 2 16 3 17 18 4 INPUT 19 MENU 5 MUTE 20 CH+ 6 VOL- ENTER VOL+ 21 EXIT CH- RECALL 7 22 8 USB PLAY/PAUSE STOP REPEAT 23 9 REV PREV NEXT 24 10 25 11 DISPLAY GUIDE FAVORITE CH.LIST 26 12 27 13 28 Color buttons Red Green Yellow Blue UP DOWN LEFT RIGHT When functions are attached to the color buttons, the color buttons are shown on screen. 1 PICTURE 2 ARC 3 CCD (closed caption) 4 INPUT 5 MENU 6 Thumbstick (Up/Down/ Left/Right) 7 EXIT 8 USB 9 USB PLAY/PAUSE 0 USB fast reverse A USB fast forward B DISPLAY C GUIDE D Power E AUDIO F SLEEP button G MTS/SAP H Number buttons I • button J MUTE K ENTER L RECALL M USB REPEAT N USB STOP O USB Next Chapter P USB Previous Chapter Q CH.LIST R FAVORITE Press repeatedly to cycle through the available picture modes Select the aspect ratio Select a closed caption option Show the input source Press to open the on-screen menu Volume/Channel Selection, Allows you to navigate the on-screen menus and adjust the system settings to your preference. Clears all on-screen displays and returns to TV viewing from any menu Press to switch input source to USB in Press to display the TV status information on the top of the TV screen Display the guide when you are watching analog or digital channels Press to turn on and off the TV Press to cycle through different sound settings Press to display the sleep timer option Select MONO, STEREO, SAP in NTSC system Press to change a channel Press to select digital channels. For example, to enter "54-3", press "54", "• " and "3" Switches the sound on or off Accesses the highlighted item in the on-screen menu Press to jump back and forth between two channels Open the channel list in TV Open the favourite channel list in TV Haier LED HDTV EN-6