Haier HLP021WM User Manual - Page 15
Installing the Lint Filter - user manual
View all Haier HLP021WM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English 6. The drain hose must be placed into a drainpipe or sink at least 1-1/2 inches in diameter. Use the gooseneck drain hook to hold the hose in place. To avoid possible water back-up, the drain hose must reach a height of at least 31-1/2 inches minimum and 40 inches maximum. Laundry tub: Just hang hook over side of sink or for a more permanent use plastic ties. Drain Hook Drain Hook Plastic Tie Final connection of washer to sink should look like this. 7. Make sure the lint filter is installed. The lint filter must be installed before the washer is used. The lint filter is packaged with the User Manual. 8. Plug in the washer to a regular 115 Volt / 60 Hz, 15 Amps outlet, only after all water and drain lines are connected . Note: Carefully inspect for any leaks around the machine and at the back. If there is a leak, check if any connections are loose. You may need to tighten any loose connections. Do not remove the water absorption cushion. Check before each use to make sure it is not damaged. CAUTION! If after completing these steps you are still unsure whether unit has been properly installed, contact a qualified installer. We recommend WARNING that the washer be installed by a certified technician to ensure that it is properly installed. Installing the Lint Filter The lint filter must be installed before the washer is used. The lint filter is packaged with the User Manual. 14