Haier HLT364XXQ User Manual - Page 17
Steps for Installation
View all Haier HLT364XXQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Steps for Installation Select a away suitable location for the washer on a hard even surface from direct sunlight or heat source e.g. radiators, base board heaters, cooking appliances etc.Any floor unevenness should be corrected with the leveling legs located on the bottom corners of the washer.The washer must be placed at room temperature.You must not place washer where the temperature is at below freezing. Installing Your Washer: Read through these instructions carefully before installation. 1. Connect the hot and cold water inlet hoses to the hot and cold water faucet. Cold water inlet hose Hot water inlet hose 2. Connect the other end to the corresponding washer inlet located at the back of machine. HC Note: You may have to use pliers to tighten the coupling. Do not over tighten because you may cause damage to the valve. You should use the new hose-sets supplied with the washer. Old hose-sets should not be reused. 16