Haier HLTD600AGW User Manual - Page 13

ELECTRIC DRYER (CANADA ONLY) WARNING The dryer must be plugged into a properly grounded 4-wire, single phase, 120/240 volt, 60Hz, AC-only electrical outlet connected to an individual 30-amp circuit, fused with a 30-amp time-delay fuse or circuit breaker. Do not operate a washer and dryer on the same circuit. NOTE: The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the CSA C22.1 Canadian Electrical Code Part 1. • If the electrical supply available in the intended dryer location does not meet the above requirements, contact a licensed electrician. • All Canadian models are shipped with the power cord attached. The power cord should be plugged into a 30-ampere receptacle. In Canada, you may not convert a dryer to 208 volts. • The electrical outlet should be located so that the power cord is accessible when the dryer is in the installed position. GAS DRYER ELECTRICAL SUPPLY REQUIREMENTS WARNING The gas dryer must be plugged into a properly grounded 3-wire, single phase, 120 volt, 60Hz, AC-only electrical outlet, fused with a 15-amp time-delay fuse or circuit breaker. • The dryer is equipped with a power cord that has a 3 prong plug. Do not cut or remove the grounding prong from the power cord. • The power cord must be plugged into a mating, 3 prong outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, contacted a licensed electrician to have one installed. • If you are not sure if your outlet is properly grounded, contact a licensed electrician. • Do not use a 3 prong plug adapter. • Do not use an extension cord. 11