Haier HPIMD25S Product Manual - Page 11

English TRoubleshooting guide Problem Possible Causes Power LED indicator Plug disconnected from wall will not come on outlet "Ice Full" LED indicator is on Storage compartment is full Solution Check that unit is plugged into standard 120V, 60 Hz outlet. Also make sure outlet has power and circuit breaker is not tripped. Remove ice from storage compartment via the dispenser Ice cubes in storage compartment but do not come out the dispenser Transparent hatch is open Auger in ice storage compartment is blocked "Add Water" LED indicator is on Water reservoir is empty or water level is low Ice making cycle is normal but no ice is made Ambient temperature or water temperature inside reservoir is to high Refrigerant liquid leakage. Pipe in the cooling system is blocked. Solid block of ice Ice dispensing not complete forms on evaporator from storage compartment Close hatch securely, resetting safety switch and reactivating auger Release ice dispenser paddle, wait 10 seconds, push ice dispenser paddle forward again Use provided funnel to add water to reservoir on side of unit. Operate ice makers at ambient temperature below 90˚ and pour colder water into reservoir. Turn power off, unplug unit and contact a qualified technician. Turn power off, unplug unit and contact a qualified technician. Unplug and allow ice to melt (never use sharp object to remove ice). Note: There is protective circuitry inside this icemaker to protect the circuitry from overheating and the icemaker will automatically shut down to prevent damage if activated. Please disconnect power cord and restart after 30 minutes of cooling down time. For Haier Customer Service, please call: 1-877-337-3639 10