Haier HPU-44H03 User Manual - Page 14
Timer on/off operation
View all Haier HPU-44H03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Operation Timer on/off operation Manual Operation 23 TIMER CLOCK TIME TIME SET SLEEP 4 : AM TIMER ON AM : LOW MID HIGH ROOM TEMP TEMP MODE C TEMP ON OFF SWING FAN SPEED 1 Remote controlled operation TIMER operation Set Clock correctly before starting Timer operation (refer to page 5) You can let unit start or stop automatically at following times: Before you wake up in the moring, or get back from outside or after you fall asleep at night. TIMER ON/OFF (1) After unit start, select your desired operation mode. Operation mode will be displayed on LCD. (2) TIMER mode selection Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: Manual TIMER ON AM 12:00 TIMER ON TIMER OFF AM 12:00 TIMER OFF TIMER ON AM 12:00 TIMER OFF AM 12:00 TIMER ON-OFF BLANK Remote control ON AM 12:00 TIMER ON OFF PM 12:00 TIMER OFF ON OFF AM 12:00 PM 12:00 TIMER ON-OFF BLANK AM ON AM Select your desires TIMER mide (TIMER ON or TIMEROFF) ON or OFF will flash. (3) Timer setting Press HOUR / button. Every time the button is pressed, time increases 10 min, If button is kept pressed, time will change quickly. Every time the button is pressed, time decreases 10 min, If button is kept pressed, time will change quickly. Time will be shown on LCD. It can be adjusted within 24 hours. (4) Confirming your setting After setting correct time, press SET button to confirm, " ON " or " OFF " stops flashing. Time displayed: Unit starts or stops at x hour x min (TIMER ON or TIMER OFF) Timer mode indicator on indoor unit lights up. TEMP ON SWING OFF FAN 1 MODE SLEEP CLOCK SET TIMER 4 2LOCK 3 RESET To cancel TIMER mode Just press TIMER button several times until TIMER mode disappears. Hints After replacing batteries or a power failure happens, Time setting should be reset. Remote controller possesses memory function when use TIMER mode next time, just Press SET button after mode selecting if timer setting is the same as previous one. 12