Haier HRF-250S User Manual - Page 6
Additional Feature
View all Haier HRF-250S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Additional Feature Changing the opening directions of the doors: It is possible to change the side from which the refrigerator door opens. The procedures for this are as follows: Loosen the middle hinge (1), and remove the freezer door (2) and refrigerator door (3). Remove the lower hinge seat (4). Revolve the upper hinge axle (5), remove it, and assemble it on the left side. Remove the screw cover (6), and insert it in the hole on the right side of the refrigerator. Assemble the lower hinge seat (4) to the left side of the refrigerator. If your refrigerator has end caps instead of handles, ignore the next 3 steps. Remove the screw cover (7). Remove the handles of the freezer (9) and refrigerator (8) doors and exchange them. Assemble them on the right side of the refrigerator (3) and freezer (2) doors. Assemble the screw cover (7) to the left side of the refrigerator door. Assemble the freezer door (2), refrigerator door (3) and the middle hinge (1) together to the refrigerator. 5 2 7 8 1 6 4 7 3 9 4 7 5 67 7 1 7 2 9 8 3 4 Trouble Shooting Tips Performance problems are sometimes caused by minor things which can be corrected simply, without having to call a Service Engineer. PROBLEM / SYMPTOM CHECK LIST A) Refrigerator will not work 1. Is the mains cable plugged in? 2. Is the electrical supply turned on? 3. Is the temperature control knob set to "O" or too low? 4. Has the fuse blown? ACTION / REMEDY 1. Plug in and switch on. 2. Turn on electrical supply. 3. Select higher setting. 4. Replace with correct size fuse. B) Compressor appears to 1. Is the temperature run constantly. control knob set very hight? 1. Adjust as necessary 2. Is the door opened frequently? 2. Reduce frequency of door openings. 3. Is there sufficient air gap between the back of the refrigerator and the rear wall? 3. Pull refrigerator away from the wall. 4. Is the condenser behind 4. If not, clean as in previous. the unit free of dust or dirt? table. C) Light does not work. Note: On hot days,or if room is warm,the compressor will automatically run for longer periods. Inspect bulb to see if it has blown or is loose Replace if necessary with appliance bulb(max 15 watts) Having tried the above and should the unit still fail to operate, switch off and call a Service Engineer. 9