Haier HRF-689FF User Manual - Page 4

Safety precautions Safety precautions This refrigerator requires a 220-240V supply Failure in operation and damage to the control panel, thermostat or the compressor will occur if voltage is outside the range 187-242V unless a regulator with a capacity of over 750W or higher is installed. 220-240V~ 50Hz A separate earthed socket is required. The refrigerator is supplied with a standard threepin plug, of which the one for grounding should never be removed. Plug of installed refrigerator shall be always accessible, ensuring that the plug is tightly inserted into the socket, or fire may be caused. Care for external cable * Hold the plug, not the electric cable, when unplugging the refrigerator. * Ensure that the electric cable is not trapped by the refrigerator. Do not step on the cable. * Avoid damage to the electric cable when moving the refrigerator. Damaged electric cable When the electrical cable is damaged or worn, turn off the refrigerator and consult to an authorized service agent for replacement. Inflammable gas leakage in the vicinity of the refrigerator * Turn off any leaking valve; * Open the doors and windows; * Do not, under any circumstances, unplug electrical appliances in the vicinity of the leak. Unplug the refrigerator for the following: * Cleaning or maintenance; * Replacement of lamp. 2 Troubleshooting In the event that the refrigerator does not work properly, please check out and solve problems according to the following methods. If problems persist, contact the after-sales service center. Information of model, accessory list and serial number of the refrigerator is required. (see the type plate of the refrigerator) Please determine the cause of the problem before making any repair. The refrigerator does not operate. Disconnection to the power supply (plug, socket or fuse); Switch is off. Voltage is low. Automatic defrosting is activated. (Compressor ceases operation for 30 minutes) Lamp does not illuminate. Excessive noise The bulb is bad. Power supply is not connected. Set temperature not reached. Uneven placement. Contact between the refrigerator and a wall or other article. Door is not properly closed, or the door is opened for long period; Refrigerator is in direct sunlight, or close to a heat source; The area is poorly ventilated, or the two sides of the refrigerator are covered by too much dust. 31