Haier HSU-12HVd03 User Manual - Page 2

Parts and Functions Indoor Unit Remote controller Inlet grille Air purifying Filter(inside) Inlet Anion generator (inside) Horizontal flap (adjust up and down air flow Don't adjust it manually) Outlet Vertical blade (adjust left and right air flow) Display board Please be subject to the actual produce purchased the above picture is just from your reference Display board       Singal receiver hole TIMER OFF display CADAUOmryTObOiLdenidsdt itpisesplmpallapay.yydisplay When receiving the remote control signal, display the set temperature and in the rest TIMER ON display SLEEP display  HEAT display HEALTH display (If the unit which you purchased has healthy function,follow it. If not,please ignore.) time the room temperature is displayed and this room temperature is only for reference.  FRESH AIR display Outdoor Unit 19 10. ON/OFF button 11. TIMER ON display 12. FAN SPEED display LOW MED HI AUTO 13. LOCK display 14. SWING UP/DOWN display 15. SLEEP display 16. HEALTH display 17.FRESH AIR display 18. Operation mode display 28 Operation mode AUTO COOL DRY HEAT FAN FRESH Remote con troll er STERILIZE Display board 19.Singal sending display 20. UV light degerming function display 33 21. Left/right air flow display 22. TEMP display 23. TIMER OFF display 24. TIMER/SLEEP display 25. TEMP button 26. FAN button 1.CODE 27. HEALTH AIRFLOW button Used to select CODE A or B with a press, A or B will be displayed on LCD. 28. SWING UP/DOWN button Please select A without special explanation. 29. SWING LEFT/RIGHT button 2.RESET When the remote controller appears abnormal, use a sharp pointed article to press this button to reset the remote controller normal. 3.LIGHT button Control the lightening and extinguishing of the indoor LED display board. 4. TIMER button 5. CLOCK button 6. SLEEP button 7. MODE button 8. HOUR button 9. HEALTH button 30. FRESH button 31. SET button 32. STERILIZE button 33. LOCK Used to lock buttons and LCD display.If pressed,the other buttons will be disabled and the lock condition display appears. Press it once again,lock will be canceled and lock condition display disappears. 34. Ambient temp.display When receiving the remote control signal, display the set temperatrue and in the rest time the room temperature is displayed and this room temperature is only for reference. NOTE : The following functions and related displays are not available: 1 Loading of the battery OUTLET INLET CONNECTING PIPING AND ELECTRICAL WIRING  DRAIN HOSE Please be subject to the actual produce purchased the above picture is just from your reference Clock set Press CLOCK button, "AM" or "PM" flashes. Press or to set correct time. Each press will increase or decrease 1min. If the button is kept pressed,time will change quickly. After time setting is confirmed,press SET, "AM "and "PM" stop flashing,while clock starts working. STERILIZE 1 Remove the battery cover; 2   Load the batteries as illustrated. 2 R-03 batteries, resetting key  (cylinder); 3 Be sure that the loading  is in line with the" + "/"-"; 4 Load the battery,then put on the cover again. Note: The distance between the signal transmission head and the rece- iver hole should be within 7m without any obstacle as well. When electronic-sta rted type fluorescent lamp or change- over type fluorescent lamp or wireless telephone is installed in the room, the recei ver is apt to be disturbed in receiving the signals, so the distance to the indoor unit should be shorter. Full display or unclear display during operation indicates the batteries have been used up.Please change batteries. If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later. Hint: Remove the batteries in case unit won't be in usage for a long period . If there are any display after taking-out, just need to press reset key. 2