Haier HSU-12HVd03 User Manual - Page 6

Maintenance For Smart Use of The Air Conditioner Setting of proper room temperature Do not block the air inlet or outlet Remote Controller Indoor Body Proper temperature Close doors and windows Use the timer effectively during operation During cooling operation prevent the penetration of direct sunlight with curtain or blind If the unit is not to be used for a long time, turn off the power supply main switch. Use the louvers effectively OFF Do not use water,wipe the controller with a dry cloth.Do not use glass cleaner or chemical cloth. wipe the air conditioner by using a soft and dry cloth.For serious stains, use a neutral detergent diluted with water.Wring the water out of the cloth before wiping,then wipe off the detergent completely. Do not use the following for cleaning Gasoline,benzine, thinner or cleanser Hot water over 40OC(104OF) may may damage the coating of the unit. cause discoloring or deformation. Air Filter cleaning Open the inlet grille by pulling it upward. Remove the filter. Push up the filter's center tab slightly until it is released from the stopper, and remove the filter downward. Clean the filter. Use a vacuum cleaner to remove dust, or wash the filter with water.After washing, dry the filter completely in the shade. Attach the filter. Attach the filter correctly so that the "FRONT" indication is facing to the front.Make sure that the filter is completely fixed behind the stopper.If the right and left filters are not attached correctly, that may cause defects. Once every two weeks Close the inlet grille. Replacement of Air Purifying Filter 1.Open the lnlet Grille Prop up the inlet grille by using a small device named grille-support which located in the right side of the indoor unit. 2.Detach the standard air filter Slide the knob slightly upward to release the filter, then withdraw it. Detach old Air Purifying Filter 3.Attach Air Purifying Filter Put air purifying filter appliances into the right and left filter frames. 4.Attach the standard air filter (Necessary installation) 6 The green aspect of the bacteria-killing medium air purifying filter will face outside, the white aspect will face to the machine. Note: the bacteria-killing mediums placed on the left side. The multi-lights touching intermediary is placed on the right side. 5.Close the Inlet Grille Close the Grille surely Common sense: 1.For the units with UV light degerming function, the air purifying filter of the bacteria-killing medium and the multi-lights touching intermediary is effective for a long time and don't need to be changed(UV light emitted by the UV light device of the indoor unit catalytically activates the nano TiO2 on the multi-lights touching intermediary, and the degerming effect is highly efficient and lasting.Multi-lights touching intermediary don't need to be exposed to be sunlight). 2.For the units without UV light degerming function, the air purifying filter of the multi-lights touching intermediary will be solarized in fixed time. In normal family, it will be solarized every 6 months. The solarization time will last no less than 8 hours under the state of abundant sun. 3.But in the use, please note to clean the filter frequently( take off the back suction cleaner or lightly pat it) to avoid the operating effect is lowered due to the dust covering the filter. Multi-lights touching intermediary and bacteria-killing medium filter is strictly prohibited from being cleaned by water. The bacteria-killing medium filter not in use should be stored in shade, cool and dry place.Please don't expose it to the sunlight for a long time otherwise the degerming performance will drop.