Haier HSU-18HRA03 User Manual - Page 12
If the unit which you purchased has not healthy function, Remote controller should, like
View all Haier HSU-18HRA03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Parts and Functions If the unit which you purchased has not healthy function, Remote controller should like the following figure: Remote controller Display board 1 6 2 7 3 8 9 10 5 ON/OFF 11 25 1 1 26 1 89 5 19 13 FAN 20 MODE 14 SWING 21 15 TIMER 22 16 CLOCK 17 SET SLEEP 23 LOCK RESET 18 24 1. Operation mode display Operation mode AUTO COOL DRY HEAT FAN Remote controller Display board 2. SWING display 3. FAN SPEED display 5. SLEEP display 6. LOCK display Clock set AUTO LO MED HI 7. SIGNAL SENDING display 8. TIMER OFF display 9. TIMER ON display 10. CLOCK display 11. TEMP display 13. FAN Used to select fan speed LO, MED, HI, AUTO 14. SWING Used to set auto fan direction. 15. TIMER Used to select TIMER ON, TIMER OFF, TIMER ON-OFF 16. CLOCK Used to set correct time 17. SET Used to confirm timer and clock settings. 18. LOCK Used to lock buttons and LCD display. 19. POWER ON/OFF Used for unit start and stop. 20. TEMP. Used to select your desired temp. 21. MODE Used to select AUTO run, COOL, DRY and FAN operation 22. HOUR Used to set clock and timer setting. 23. SLEEP Used to select sleep mode. 24. RESET Used to reset the controller back to normal condition. 25. Singal receiver hole 26. Ambient temp.display When receiving the remote control signal, display the set temperature and in the rest time the room temperature is displayed and this room temperature is only for reference. When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM" or "PM" flashes. Press or to set correct time. Each press will increase or decrease 1min. If the button is kept depressed, time will change quickly. After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock starts working. NOTE: Cooling only unit do not have displays and functions related with heating Hints After replacing with new batteries, remote controller will conduct self-check, displaying all information on LCD. Then, it will become normal. 7