Haier HT18TS45SW HT18TW10SW - Page 6

ENGLISH ELECTRICAL REQUIREMENTS GROUNDING INSTRUCTIONS WARNING ELECTRICAL REQUIREMENT - SHOCK HAZARD • Make sure there is a suitable power outlet. 115 Volts, 15 Amps, 3 Prong (Grounded) power outlet with proper grounding to power the refrigerator. • Avoid the use of three prong adapters or cutting off the third grounding prong in order to accommodate a two prong outlet. This is a dangerous practice since it provides no effective grounding for the refrigerator and may result in shock hazard. USE OF EXTENSION CORDS WARNING USE OF EXTENSION CORDS- POTENTIAL SAFETY HAZARD • Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the appliance. DO NOT USE EXTENSION CORD LONGER THAN 12 FT. INSTALLATION GUIDE INSTALLATION LIMITATIONS • Select a suitable location for the refrigerator on a hard even surface away from direct sunlight or heat source, e.g. radiators, baseboard heaters, cooking appliances, etc. Any floor unevenness should be corrected with the leveling legs located on the front bottom corners of the refrigerator. UNPACKING YOUR REFRIGERATOR 1. Remove all packaging material. This includes the corrugated base and all adhesive tape holding the refrigerator accessories inside and outside. 2. Inspect and remove any remains of packing, tape or printed materials before powering on the refrigerator. NOTE: If your refrigerator comes with a snack pan, remove the blue adhesive tape from the rear of the pan. The pan will not slide in and out without removing the tape. PAGE 4 • SET UP & USE