Haier HWB1260 Operation Manual - Page 5
Troubleshooting - manual
View all Haier HWB1260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Precautions 3.Do not place heavy objects or container with water on the washing machine,so as to prevent deformation of the flat surface and plastic parts. 4. Do not wash articles containing polystyrene or similar elastic materials. 5. Before washing, do up zippers and ensure 6.Do not open the detergent drawing that buttons are securely fastened. Place during the wash cycle. small items, such as socks,belts,etc. in a small washing bag or a pillow-case . To protect the washing machine, do not wash garments containing wire parts. 7. The door is fitted with a self-lock device and can not be opened until 2-3 minutes after the end of the programme.You are not recommended not to force the door open before the programme end. Do not open the door if the water level is above the lower part of the door. 8. At the end of the wash cycle, turn off the water supply to prevent water leakage, unplug the washing machine and thoroughly clean the trim so as not to dirty the laundry in the next wash cycle. 9.For appliances with type Y attachment,the 10.The installation instructions shall state intructions shall contain the substance of the that the appliance is to be connected to the following. water mains using new hose-sets and that If the supply cord is damaged,it must be the old should not be used. replaced by the manufacturer,its service For washing machines with ventilation agent or similarly qualifled persons in order openings in the base,that a carpet must not to avoid a hazard. obstruct the openings. Troubleshooting The following circumstances do not constitute problems. Do not contact the maintenance service until the problem has been confirmed. Problem Possible cause The washing machine fails to operate Poor connection to power supply Power failure Door is not properly closed (It will show E1) Machine has not been switched on Washing machine cannot be filled with water The machine is draining while is being filled Drainage failure Strong vibration during spin drying Water tap is not turned on(It will show E4) Water pressure is less than 0.03Mpa The inlet hose is kinked Water supply failure The program dial is not properly set The door is not properly closed The inlet hose filter is blocked The height of the drainage hose is below 80cm (it should be within 80-100cm) The drainage hose end is in water Drainage hose is blocked (It will show E2) Drainage hose end is exceed 100cm above the floor level The filter is blocked Not all packing bolts have been removed Washing machine is located on an uneven surface Machine load is over 5kg. Operation stops before completion of a wash cycle Water or electricity failure Washing machine is in soak cycle Operation stops for a period of time Washing machine is in soak cycle Washing machine gives an error message. Excessive foam in the drum, which is spilled to the distribution drawer The detergent is not a low-foaming type or for manual wash Excessive use of detergent