Haier HWM1270KFL User Manual - Page 5
Installation - 7kg
View all Haier HWM1270KFL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Troubleshooting The following circumstances do not constitute problems. Do not contact the maintenance service until the problem has been confirmed. Problem Possible cause The washing machine fails to operate Poor connection to power supply Power failure Door is not properly closed (It will show E1) Machine has not been switched on Washing machine does not fill up with water The machine is draining while also being filled Drainage failure Strong vibration during spin drying Water tap is not turned on(It will show E5) Water pressure is less than 0.03MPa The inlet hose is kinked Water supply failure The program dial is not properly set The door is not properly closed The inlet hose filter is blocked The height of the drainage hose is below 80cm (it should be within 80-100cm) The drainage hose end is in water Drainage hose is blocked (It will show E2) Drainage hose end exceeds 100cm above the floor level The filter is blocked Not all packing bolts have been removed Washing machine is located on an uneven surface Machine load is over 7kg. Not all foam packing has been removed from the motor Operation stops before completion of a wash cycle Water or electricity failure Washing machine is in soak cycle Operation stops for a period of time Washing machine is in soak cycle Washing machine gives an error message. Excessive foam in the drum, which is spilled to the distribution drawer 13 The detergent is not a low-foaming type or for manual wash Excessive use of detergent Installation ƽ Remove all the packing materials (including the foam base)to prevent vibration during use, as shown in Fig.1.Upon opening of the package, water drops may be seen on the plastic bag and the porthole. This is normal resulting from water test in the factory. ƽ Check attachments and materials with reference to the following Qty Name Operation manual Model Quality certificate Water hose Drainage holder Plastic plugs HWM1270KFL 1 1 2 1 3 Fig. 1 ƽ Dismantle the packing bolts as shown in Fig. 2. The packing bolts are designed for clamping anti-vibration components inside of the washing machine during the transportation process. Before use: 1. Remove the back plate; 2. Remove the three packing bolts on the back plate and take out the rubber hose; 3. Replace the back plate; 4. Fill the holes left by the packing bolts with plastic plugs. (Attention: The packing bolts and rubber hose should be kept in a safe place for later use) ƽ Adjusting the washing machine There are adjustable feet under the bottom of the washing machine. Before use, the washing machine should be adjusted, as shown in Fig. 3, so that it is level. Fig.2 Fig.3 4