Haier HWM50-10B User Manual - Page 17

Trouble shooting·Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena Buzzing upon reservation starts, Nixie tube indicates "E0" No or slow drain, nixie tube indicates "E1" , buzzing. Running pauses during spin, nixie tube indicates "E2", buzzing The reason The top lid is not closed Is the drain hose put down? Is the drain hose blocked by foreign material? The top cover leaves open How to settle Close the top lid Put down the drain hose. Open and close the top lid once. Clean the fore ign material. Open and close the top lid once. Close the top lid Safety switch actuat es, no t spi n, (after sel f-corr ecti on twice), ni xi e tub e di spl ays "E3", bu zzi ng No or slow water filling（not reaching the level in 15min ）, nixie tube indicates "E4", buzzing Are the laundries put slantingly? Is the machine slanting? The water tap is not open The water inlet valve is blocked The water pressure is too low and the current is too small Re-or der the laun dri es. Close the top lid.Leve l the machi ne in right posi tion. Open and cl ose the top lid once . Open the wa ter tap. Push the "Start/Pause" bu tton. Clean the wa ter inlet valve. push the "Start/Pause" bu tton. Wait for the no rma l water pr essure be fore us e. Poor or no waterfall flow The machine does not act Not wash Not spin There's abnormal sound inside the machine The water faucet leaks If the nozzle is choked with foreign bodies Is there power failure? Is the power plug loose? Does the water level arrive at the set water level? Is the power plug loose? Is the top lid closed? Are the laundries put orderly? Is the machine slanting? Are the laundries slanting in spinning? Is the jointer screw of the water inlet hose is loose or twisted awry? Remove the foreign bodies Use it when the power is on. Insert the power plug tightly. Affusion to the set water level. Insert the power plug tightly. Close the top lid Put the laundries orderly. Level the machine properly. Re-order the laundries. Fasten the jointer screw properly. Common phenomena Phenomena Explanation The spinning is intermittent when it starts. Push the "Procedure selection" button to select "Spin", but it doesn't work. There may be some water flowing out of the drain hose in the first use of the machine. While water filling in wash and rinse, the pulsator pauses rotation Wash pauses Balance the laundries to avoid slanting. The program is setting the drain time. Some time is needed before it starts spinning. It is the water remained in the factory inspection of performance. To prevent splash during water filling. Supplementary water filling 48 s after sensor tests cloth material. 15