Haier HWM60-15P User Manual - Page 6
Installation and adjustment
View all Haier HWM60-15P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Voltage change This washer is assembled for 220V, but can be changed from 220V to 127V. Check your electrical source and follow the diagram below to convert voltage. Green Blue White (1). Please first pull off the power plug and hang up the power cord. (2). Loosen the fastening screw and take off the back cover. (3). Unknit the safeguard bag to expose the connectors. (4). Detach the white connector from the green one(220V), then inlay it into the blue one(127V). (5). Pack all the connectors with the safeguard bag as usual and fix it. Then install the back cover. Above all the steps must be done by the special serviceman. If you do not need spraying spin, you can Quick water-filling entrance fill water into the wash tub directly through this entrance. It can reduce the humidity Water inlet hose inside the control panel significantly and prolong the operating life of the components. Push Control handle Water inlet jointer Quick water-filling entrance Install the lint filter After opening the package,please take out the lint filter from the document bag,install it to the overflow filter of the wash tub.See to the figure. Overflow filter Usage of the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage willnot be smooth enough and cause incomplete drainage. 2.Do not tramp or press the drain hose. 3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly. Lint filter