Haier HWM65-0566 User Manual - Page 7

b Steps of using the operation buttons and description of the steps 43 46 Standard Normal Tub dry 20 36 40 Fibre Quick 15 28 32 Woollen Jean 20 24 12 16 Soak Wash Rinse Spin Reserve Water level Program Tub dry Power 6 5 1.Push "power" button to switch on the power Power 2.Push "program" button to select suitable full-auto program After the power is switched on, "normal"is automatically set. To select other full-auto program, please push the "program" button till the corresponding indicator is on. Refer to the "Program button" on Page 11. E.g. Set to "Quick wash" program for small quantity of laundries with light soil. In selecting the NORMAL or standard program, the machine will execute fuzzy program to select water and wash time according to the cloth and weight of the laundries. The full procedure is controlled automatically. Push the "SOAK", "WASH", "RINSE" OR "SPIN" button to select suitable procedure. Soak Wash Rinse Spin 12 How to change the direction of the drain hose 1.Dismantle the rear cover of the washing machine. 3.Dismantle the drain outlet protecting cover at the other side, (the way is the same as the drain bushing),then install the drain 2.Put down the drain hose Take off the drain hose bushing, as indicated in Figure 4. frame as indicated in Figure 1.Take the drain hose into the cabinet then nip the drain fixing clamp to make 4.Extend the drain hose from the other side. Fix the drain hose it deviated from the clip the other hand is used to put with drain hose frame onto the cabinet, as indicated in Figure 5. down the drain bushing as indicated in Figure 2 3. drain outlet protecting cover Drain hose Drain hose support Figure 1 Cabinet Inner Outer Push Drain bushing Figure 2 Drain bushing Drain bushing Figure 4 Figure 5 5.Install the drain outlet protecting cover to the other side, as indicated in Figure 6 Drain hose fixing clamp Push Take down Figure 3 Figure 6 Remarks: in order to make sure of the correct of installation, it is suggested to change the direction of the drain hose with our company serviceman . Usage the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm, 4.If extra drain hose is needed, please make separate or the drainage will not be smooth, and cost such long purchase. The inner diameter of the extra hose shall time that the machine may stop at mid way. not less than 30mm, and the length shall not exceed 2.Do not step on or press the drain hose. 1.5m. 3. If the drain hose is too long, cut it at mid point. To make 5.If the extra hose is too long, cut it either at A or at B. smooth drainage, cut the front end of the hose slantingly. 5