Haier HWM90-7288 User Manual - Page 15

Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or aftepsale service department of our company. Do not repair it by yourself. Phenomenan The reason How to settle The digitron displays EO. • The top lid is opened during reserve procedure. The drainage cannot work, or is too slow. • Is the drain hose blocked? The digitron displays El. It stops running in midway. The digitron displays E2. • The top lid is not closed. • When using the child lock function, if the top cover is opened, the machine will stop and display E2 alarm. After 15 minutes the machine will automatic drainage Close the top lid. • Clean the foreign material. Open and close The top Lid Once. • Close the top lid. . dear the E2 alarm, please close the top cover and press the "START/PAUSE" button. Then E2 alarm will be cleared. The safety switch acts, and the spinning cannot work. The digitron displays E3. • Are the laundries put slantingly? • Is the machine slanting? The water filling does not work, or is • Is the water tap opened, or is there water slow,the digital displays E4. supply failure? • Is the water inlet valve blocked? • Is the water pressure too low? • Reorder the laundries. Close the top lid. • The machine will start running after 10 seconds of being placed honzontally. • Open the water tap. Push the start/Pause button once. • Clean the water inlet valve then push the start/Pause button once. • Use after the water pressure is normal. The digitron displays E6. The digitron displays F2. • The water level sensor is bad. • Overflow alarm • Please contact the after-sales service department. • Please contact the after-sales service department. The machine does not act Not wash Not spin • Is there power failure? • Please use it when there's power supply. • Is the power plug inserted tightly? • Insert the power plug tightly. • Is the water level reached preset position? . Fill water to the preset position. • Is the power plug inserted tightly? • • Is the top lid closed reliably? Are the laundries set flat? • Insert the power plug tightly. • Close the top lid. • Set the laundries flat. There's abnormal sound inside the machine The water tap leaks • Is the machine slanting? • Are the laundries put slantingly in spinning? • Are there any foreign materials? • is the jointer of water inlet hose loose or awry? • Adjust the machine to be even • Reorder the laundries and close the top lid. • Remove the foreign materials. • Fasten the jointer properly. Common phenomena Phenomena Explanation • • The spinning is intermittent when it starts. • Balance the laundries to avoid slanting. • Push the "spin" button to select "Spin", but it doesn't work. • The final spinning is finished,it becomes rinsing and begins to inlet water. • When the power plug is inserted,computer board indicator is switched on,and the machine starts working. • The program is setting the drain time. Some time is needed before it starts spinning. • Because the washing clothes lean to one side,the safety switch acts.After water filling and running,eliminating the eccentricity of washing clothes,then beginning to spin. • It is the special resume function.ln the case of power failure or the power plug is loose during washing,the machine can save the running program,and resume the program afterthe power supply is recobered.You do not need to set the program again 13