Haier HWM90-7288 User Manual - Page 7

Install the water inlet hose (Confirm the water tap Water tap, suitable Outlet end surface Water tap, not suitable >10mm It is required that the frontend shall be longer than 10mm. The outlet end surface of the tap shall be flat and smooth. If not please file it to avoid leakage. Connection between the water inlet hose jointer and the water tap KLUse the new water inlet hose provided with the machine to connect to the water faucet.Old hose sets should not be reused. 2.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. 3.Loosen the screw till the water tap can be accessed. Put the jointer of the water inlet hose on the tap. See to Figure 2. (If the tap diameter is too large and the jointer can not be set on the water tap, please loosen the four screws and take out the bushing in the jointer. See to the figure3.) Water inlet pipe jointer Slider Screw kCli"rli Locking lever Screwdriver Mark label Bushing Water inlet pipe Figure 1 Figure 2 Figure 3 4.Fasten the four screws evenly. See to Figure 4. 5.Take off the nameplate. Twist the fastening nut as per the indication of the figure. See to Figure 5. Remarks: Before twisting the fastening nut, the thread is 4mm above the upper surface ofthe nut. After twisting thefastening nut, the thread is 2mm above the uppersurface of the nut. See to Figure 6. About 4mm before twisting About below 2mm after twisting Figure 4 Nut Figure 5 Figure 6 J 5