Haier RWT300AW User Manual - Page 21

Steps for Installation English Select a suitable location for the washer on a hard even surface away from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the bottom corners of the washer. The washer must be placed at room temperature. You must not place washer where the temperature is at below freezing. Installing Your Washer: Read installation instructions carefully before installation. Caution: If, after completing these steps, you are unsure that unit is properly installed, contact a qualified installer. To ensure that your Washer is properly installed it is recommended that it be installed by a certified installer. Note: 1. Insert a new flat washer into each end of the water inlet hoses. Firmly put the washers in the coupling. You may have to use pliers to tighten the coupling. Do not over tighten because you may cause damage to the valve. 2. Connect the hot and cold water inlet hoses to the hot and cold water faucet. 20