Haier TTL-700 User Manual - Page 19

Trouble-shooting Answer to question (If there's a breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena After the reservation is started, it rings and the digital tube displays "E0" The draining does not work, or the speed of draining is too slow. The digital tube displays "E1" and it rings. It stops running except water filling and draining.The digital tube displays "E2" and it rings. The safety switch acts. The spinning cannot work (after twice revising). The digital tube displays "E3" and it rings. It does not do water inlet or the speed is slow (the water level is not reached after 15 minutes). The digital tube displays "E4" and it rings. The machine does not act. (The indicators are off.) There's abnormal sound inside the machine. The water faucet leaks. Reason The top lid is not closed Is the drain hose blocked by foreign material? Is the drain hose frozen? After long running of pump in the hot weather, power will be cut automatically for safe. The top lid is not closed Are the laundries put slantingly? Is the machine slanting? Is the water faucet open or is there water supply failure? Is the water inlet valve is blocked Is there power failure? Is the power plug loose? Is the machine slanting? Is there metal material inside the washing machine? Are the laundries slanting in spinning? Is the jointer screw of the water inlet hose is loose or twisted awry? How to settle Close the top lid Clean the foreign material. Open and close the top lid once. Clean the frozen material. Some minutes later the machine will continue to work Close the top lid Re-order the laundries. Close the top lid. Level the machine in right position. Open and close the top lid once. Open the water faucet. Open and close the top lid once. Clean the water inlet valve. Open and close the top lid once. Use it when the power is on. Insert the power plug tightly. Level the machine properly. Fasten the buttons and zipper Re-order the laundries. Close the top lid. Fasten the jointer screw properly. Common phenomena Phenomena The spinning is intermittent when it starts. Pause during washing. Select spin, but it doesn't work. The pulsator pauses during water inlet in wash and rinse. There may be some water flowing out of the drain hose in the first use of the machine. 17 Explanation Balance the laundries to avoid slanting. supplemental water filled after fabric sensor has checked fabric (about 48 seconds) The program is setting the drain time. Some time is needed before it starts spinning. It is to avoid splashing during water inlet. It is the water remained in the factory inspection of performance.