Haier WQP12-AFM2 User Manual - Page 5

Wash Cycle Table Cycle Heavy Duty Button Cycle Selection Information Description of Cycle Very dirty dishes, pots and pans (not to be used with delicate items). Pre-wash with hot water. Extended wash at 65 . Rinse with cold water. Rinse with hot water. Drying. Heavy Duty Very dirty dishes, pots and pans (not to be used with delicate items). Pre-wash with hot water. Extended wash at 55 . Rinse with cold water. Rinse with hot water. Drying. Normal Wash Normally dirty dishes, pots and pans .Standard daily cycle. Extended wash at 65 . Rinse with cold water. Rinse with hot water . Drying. Detergent Rinse Aid 30 g 30 g 30 g Normal Wash IEC-EN 5MOQO Rinse R Rapid Wash Soak Extended wash at 55 . Normally dirty dishes, pots and pans .Standard daily cycle. Rinse with cold water. Rinse with hot water. 30 g Drying. For dishes that need to be rinsed and dried only. Rinse with cold water. Rinse with hot water . Drying. Economic, fast cycle to be used Short wash at 55 . to on not very dirty dishes right Cold rinse. after they are used. No drying cycle. 15 g Pre-wash of dishes, pots and pans while waiting for the load to be completed after the subsequent meal. Short cold wash to prevent food residue from drying on the dishes . .7. GB Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table". The detergent dispenser is located on the inside panel of the door. Loading the detergent To open the "A" cover on the dispenser, press the "B" button. The detergent for the wash cycle should be poured into the "C" compartment. After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place. C A Rinse Aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycles. Loading the Rinse Aid Regardless of the type detergent dispenser installed on your appliance, you must proceed as indicator below when loading the rinse aid. To open the dispenser, turn the "C" cap in the anti-clockwise direction and then pour in the rinse aid, making sure not to overfill. The amount of rinse aid used for each cycle can be regulated by turning the "F" dose adjustor, located beneath the "C" cap, with a screwdriver. There are 6 different settings; the normal dosage setting is 3. Important: Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting. B C F Notice:To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. C GB .4.