Haier WQP12-EFM User Manual - Page 5

Detergent and Rinse Aid

Page 5 highlights

Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table ". The detergent dispenser is located on the inside panel of the door. Loading the detergent To open cover "A" on the dispenser, press button "B". The detergent for the wash cycle should be poured into compartment "C". After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place. B Rinse Aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycles. Loading the Rinse Aid To open the dispenser, turn cap "C" anticlockwise and then add the rinse aid, making sure not to overfill. The amount of rinse aid used for each cycle can be regulated by turning dose adjuster "F", located beneath cap "C", with a screwdriver. There are 6 different settings; the normal dosage setting is 3. Important: Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjuster should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjuster to a lower setting. CA Notice: To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. C F .4. GB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

Detergent and Rinse Aid
Detergent
Detergent specifically intended for use with dishwashers must
be used. The dispenser must be refilled before the start of each
wash cycle following the instructions provided in the "Wash Cycle
Table ". The detergent dispenser is located on the inside panel
of the door.
Loading the detergent
To open cover "A" on the dispenser, press button "B".
The de-
tergent for the wash cycle should be poured into compartment
"C".
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
Notice: To facilitate closing the cover, remove any excess
detergent on the edges of the dispenser.
Rinse Aid
This product makes dishes sparkle and helps them to dry
without spotting. The dispenser is located on the inside
panel of the door and should be filled after every 80 wash
cycles.
Loading the Rinse Aid
To open the dispenser, turn cap "C" anticlockwise and then
add the rinse aid, making sure not to overfill.
The amount of rinse aid used for each cycle can be regu-
lated by turning dose adjuster "F", located beneath cap
"C", with a screwdriver. There are 6 different settings; the
normal dosage setting is 3.
Important:
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs,
the dosage adjuster should be turned to a higher setting.
If
the dishes have white streaks, turn the dosage adjuster to
a lower setting.
GB
.4.
F
C
B
C
A