Haier WQP12-EFM User Manual - Page 7
Turning on the Appliance
View all Haier WQP12-EFM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Turning on the Appliance Starting a wash cycle - Make sure that the plug of the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section "Loading the Dishwasher"). - Pour in the detergent (see the section "Salt, Detergent and Rinse Aid"). - Turn the knob located on the right of the control panel clock wise to the desired cycle number or symbol (see the section "Wash Cycle Table"). - Press the ON-OFF button; the ON-OFF light will turn on. At this point, the wash cycle will begin. If you forget to load some of dishes The wash cycle can be interrupted by pressing the ON-OFF button. You can then load additional dishes and turn the appliance back on. The appliance will resume operation from where it was interrupted. the ON-OFF button, turn off the water supply and open the door of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. Cancelling or modifying a wash cycle setting Premise: A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see paragraph "Loading the detergent"). Press the ON-OFF button and the ON Light will turn off. Rotate the knob clockwise to the desired cycle setting (see the section "Starting a wash cycle"). Then, turn the dishwasher back on using the ON-OFF button. At the end of the wash cycle When the knob stops turning and is aligned with the STOP mark (see figure), the cycle has finished. Turn off the appliance using .6. GB